This is a 5watt stereo power amplifier used IC BA5406. IC BA5406 contains two sets of AF power amplifiers. It delivers 5W x 2 into 3 ohm loads with a 12V supply. It has minimal power-on pop noise and has immunity to supply voltage drop. It also has minimal RF radiation.
Recommended supply voltage: 5-15V. Ideally the power supply should be able to deliver over 2.5 Amps. This means that a typical ‘cheap’ plugin power supply (wall wart) will not be good enough. The power supply leads should be as short as possible. Quiescent current 20-70mA, typically 40mA.
Recommended supply voltage: 5-15V. Ideally the power supply should be able to deliver over 2.5 Amps. This means that a typical ‘cheap’ plugin power supply (wall wart) will not be good enough. The power supply leads should be as short as possible. Quiescent current 20-70mA, typically 40mA.
Skema rangkaian 2 x 5 watt Amplifier IC BA5406 Description
The BA5406 is a monolithic dual OTL power amplifier containing two sets of high-power AF power amplifiers. The device delivers 5 watts x 2 into 30 loads with a 12V supply, or 2.8 watts x 2 into 30 loads with a 9V supply. The BA5406 features minimal power-on pop noise and immunity to supply voltage drop. With its minimal RF radiation, the device is ideally suited for use in stereo radio cassette recorders.
layout IC power BA5406
Features IC BA5406
Minimal power-on pop noise.
Immunity to supply voltage drop (operates down to Vcc=4.5V typ.).
Excellent channel balance.
Low distortion (THD=0.3% at PO=O.5W).
12.pin SIP package for mounting ease and saved space on a PC board.
Ripple filter input (pin 6) can also be used as a muting control input.
Symmetrical pin configuration facilitates art work.
Low thermal resistance of the package makes heat-sink design easy.
Built-in high-frequency phase compensation capacitor.
Minimal RF radiation allows for free system layout.
No comments:
Post a Comment